JR XP810-3 - Page 77

www.modelflight.com.au – World’s best source of JR products
4 . 6 Stunt
T
rim
(
Function Mode
)
, cont.
Press the UP and DN keys
simultaneously to enter/exit
the Function Mode
Press the DN and Select key
s
simultaneously to access th
e
Function Mode List Dis
p
la
y
To Throttle Hold
UP
DN SELECT CH CH CLEAR
Press to reset the
function
To Travel Adjust
function
Press to move
the arrow to the
channel to be
ad
j
usted
Press to increase o
r
decrease the mixin
g
value (
±
125%)
mixing value at the
arrow to the factory
pre-set (0) or to
inhibit the Stunt
Trim function
4 . 7 Throttle Hold
(
Function Mode
)
The Throttle Hold Function holds the throttle ser vo in a specific
position when the switch is activated. This is ver y useful for
practicing autorotation landings. The throttle hold switch is
located on the top right cor ner of the transmitter . The throttle hold
function is ON in the forward switch position; in the rear
position, the throttle hold function is OFF .
The factory setting for the throttle hold is inhibited. Pressing either
the + or - key will adjust the throttle hold value.
Using the + or - key, adjust the throttle hold value to deliver the
proper engine RPM for your helicopter. The adjustable range is
--2 0 through +5 0%. T o shut the engine of f during an
autorotation, a negative value may have to be input.
In Function Mode, use the UP and DN keys to select Thottle
Hold and access by pressing the UP and DN keys
simultaneously .
Initail setting
(
inhibit
)
Press either + or - key to
activate and
Increase/Decrease value
or
CLEAR
Press CLR key t
o
inhibit the Throttl
e
Hold function
ON
When the Hold switc
h
is in the "ON" position
,
the dis
p
la
y
flashes "ON"
Throttle Hold Position
V
alue
(
-20
–
+50%
)
Press the UP and DN keys
simultaneously to enter/exit
the Function Mode
Press the DN and Select key
s
simultaneously to access th
e
Function Mode List Dis
p
la
y
To Throttle Curve
UP
DN SELECT CH CH CLEAR
Press CLR to return
function
To Stunt Trim
function
Press either the
+
or - keys to set th
e
Throttle Hold value
(
-20%
–
+50%
)
the Throttle Hold
function to the
factory pre-set
inhibited (Off)
p
osition
HELI 77