Press either + or - key
to activate the Mix
function
Press to inhibit (INH)
the Mix function, or to
reset a point at the
cursor to 0
Program Mix #2 Switch Settings
On
On at all times
Hold
On at throttle hold position
F-S1
2
On at flight mode stunt #1 and stunt #2 positions
Gear
On at gear/inver
ted switch “on” position
T
o
select the desired switch setting, press the SEL key twice to
move the cursor to the SW position on the LCD screen. Next,
press either the + or - keys to select the desired switch setting.
Mixing Point Adjustment
The 5-point Programmable Mixing Function found in
programmable mixes #1 and #2 allows you to manipulate one
or all of the point values to create a non-linear “curve” of the
second, or slave, ser
vo output. Adjustment of this cur
ve only
af
fects the second, or slave, channel and has no ef
fect on the
ser
vo output of the first, or master
, channel. Points 1 and 3 are
inhibited, or inactive, until the user has input a value to the
par
ticular mixing point.
T
o
adjust the points, press the SEL key until the cursor is in line
with the “Point L” as indicated on the LCD display
. Next, press
either CH key to select the point to be adjusted.
T
o
change the value of the selected point, press either the + or -
key
. The input value for the point being adjusted will be visible
under the “Point” portion of the LCD display. Both stick input and
ser
vo output values will be shown at the lower left portion of the
LCD display
.
Note:
The ser
vo output value will not be displayed on the scree
To Next Page
Loading...
