JR XP810-3 - Page 89

www.modelflight.com.au – World’s best source of JR products
4
.
1
3 Pro
g
rammable Mixin
g
1-3
(
Function Mode
)
, cont.
Pro
g
rammable Mix #1 & #2
Master channel
Slave channel
Channel display
THRO: Throttle
AILE:
Aileron
ELEV: Elevator
RUDD: Rudder
GEAR:
Channel 5
PIT: Pitch/Aux 1
AUX 2: Aux 2
AUX 3: Aux 3
Point number (L, 1, 2, 3, H)
Mixing value (max ± 100)
Mixing switch type selected (ON, F-NR, F-S12, F-S2)
Mixing value of existing stick postition
Control stick input value
Mix
p
oint to be adusted
Press the UP and DN keys
simultaneously to enter/exit
the Function Mode
Press the DN and Select key
s
simultaneously to access th
e
Function Mode List Dis
p
la
y
UP
DN SELECT CH CH CLEAR
To Prog ram Mix i ng #1
To Gyro Sensitivity
Adjustment function
Press to move
cursor after
mix has been
activated
Press either CH
key to program the
Master/Slave
channels, or to
move the cursor to
any of the 5 points
(
L, 1, 2, 3,H
)
Press either + or - key
to select the
Master/Slave channels,
to turn exponential On
or Off, and to select
the Mixin
g
Switch t
yp
e
Press to reset the
value to the factory
p
reset at the curso
r
Programmable Mix #3
Programmable Mix #3 is similar to the previous mixes, with the
exception that there are only 3 positions where output values
can be adjusted.
A
s in the previous mixes, the first channel is considered the
master channel, with the second channel selected as the slave
channel.
This mix can be set in the computer and remain on at all times,
or it can be switched on and of f in flight using a number of
dif ferent switches.
Programmable Mix #3 uses a high and low mixing value
adjustment, as well as a mixing of fset value to redefine the
neutral position of the slave channel.
HELI 89