Chapter 4 Conning Display 4-36
4.2.3.34 Ship speed information
Item Display contents
Speed over the
ground (Bow
port-starboard
direction)
Displays the ship speed over the ground (Bow port-starboard direction). When
the ship is moving forward in the port direction, a red arrow is displayed. When
the ship is moving forward in the starboard direction, the green triangle is
displayed. (In top screen (2), a white color is used in the display instead of red
and green colors.)
If the ship speed is 1 kn or lower, the unit changes to cm/s.
The unit can be changed on the View menu.
For the details, refer to "5.1.2 Setting up the display of unit of setting value".
Speed over the
ground
(Forward-Afterward
direction)
Displays the speed over the ground (Forward-Afterward direction). When the
ship is moving forward, a green arrow is displayed. When the ship is moving
backward, a red arrow is displayed.
(In top screen (2), a white color is used in
the display instead of red and green colors.)
If the ship speed is 1 kn or lower, the unit changes to cm/s.
The unit can be changed on the View menu.
For the details, refer to "5.1.2 Setting up the display of unit of setting value".
Speed over the
ground (Stern
port-starboard
direction)
Displays the speed over the ground (Stern port-starboard direction). When the
ship is moving in the port direction, a red arrow is displayed. When the ship is
moving in the starboard direction, a green arrow is displayed.
(In top screen
(2), a white color is used in the display instead of red and green colors.)
If the ship speed is 1 kn or lower, the unit changes to cm/s.
The unit can be changed on the View menu.
For the details, refer to "5.1.2 Setting up the display of unit of setting value".
Speed over the
ground (Docking)
sensor name
combo box
Displays and changes the speed over the ground (Docking) sensor name.
The following sensor sources can be selected.
When [Menu] is selected, the [Sensor Selection/Status] dialog is displayed.
Log
*1
, Log1
*1 *2
, Log2
*1 *2
and GPSx
*3
For the details of the sensor source setting, refer to "9.1.5 Setting and
confirming the sensor source".
*1: When 1AX is installed for Log, Log cannot be selected from the sensor source.
*2: Only for the case where two Log units are available.
*3: When two or more GPS units are present, "x" indicates the unit number.
Speed over the ground [Bow port-starboard direction]
Speed over the ground [Forward-Afterward direction]
Speed over the ground [Stern port-starboard direction]
Speed over the ground [Docking] sensor name combo box
To Next Page
Loading...
