JRC JAN-9202 - Setting a Serial Port

Section 8 Adjusting and Setting Up Equipment (for Services) 8-8
8.2.3.3 Setting a serial port
In the [Serial Port] dialog, allocate the sensors to be connected for the serial port on CCU (Central
Control Unit) and the serial port on SLC/ALC.
Setting a serial port on CCU
Set each item as follows.
"Table A: Sensors that can be selected on CCU" shows selectable sensors.
However, the sensors that actually can be selected vary depending on the equipment setting.
For the sensor communication speed, refer to "Baud rates that can be selected" (setting at factory
delivery).
Setting Item Description of Setting Setting Value
Gyro 1. Select the check box and enable the serial port for the
Gyro.
2. Select a sensor to be connected to the serial port for
Gyro from the [Sensor] combo box. When not
selecting a sensor, set [ - ].
To enable: Select.
To disable: Clear.
LOG 1. Select the check box and enable the serial port for the
LOG.
2. Select a sensor to be connected to the serial port for
LOG from the [Sensor] combo box. When not
selecting a sensor, set [ - ].
To enable: Select.
To disable: Clear.
GPS 1. Select the check box and enable the serial port for the
GPS.
2. Select a sensor to be connected to the serial port for
the GPS from the [Sensor] combo box. When not
selecting a sensor, set [ - ].
To enable: Select.
To disable: Clear.
AIS 1. Select the check box and enable the serial port for the
AIS.
2. Select a sensor to be connected to the serial port for
the AIS from the [Sensor] combo box. When not
selecting a sensor, set [ - ].
To enable: Select.
To disable: Clear.