Section 9 Maintenance & Inspection 9-46
This equipment restarts during the recovery operation. Do not perform any other operations
until the recovery is completed.
Otherwise, recovery may fail, possibly causing an accident.
After completion of recovery, the following screen is displayed.
2 Turn off the power supply of this equipment by pressing the power button of the
operation unit.
9.10.4 Re-setting C-MAP
Re-set the settings of C-MAP by restarting this equipment.
Re-register the database and the licence.
Update as required.
System
Recovery succeeded.
Turn the power off and on again.
C-MAP charts has been initialized.
Set up the setting of the C-MAP
charts.
To Next Page
Loading...
