JRC JHS-183 - Page 77

5-51
c) User Key Assign
Select 3.USER KEY ASSIGN, User key assignment screen is displayed.
In this menu, Assignment to USER key can be set.
When USER KEY ASSIGN screen is displayed, the cursor is on the current setting.
Select the item with ▲ key or ▼ key and press ENT key to decide.
When “▲ ▼” mark is displayed on the left side, it means selection items continue.
Press CLR key, and then return to MY CONTROLLER MENU.
Refer to the lists following to select item
No items Explanation
1 GRAPHIC DISPLAY Displays GRAPHIC screen
2 OWN SHIP’S DETAIL1 Displays OWN SHIP’S DETAIL 1 screen
3 OWN SHIP’S DETAIL2 Displays OWN SHIP’S DETAIL 2 screen
4 POSN&TIME Displays POSN&TIME screen
5 VOYAGE DATA Displays VOYAGE DATA menu
6 MESSAGE Displays MESSAGE menu
7 MAINTENANCE Displays MAINTENANC menu
8 SET UP Displays SETUP menu
9 SELF DIAGNOSIS Displays SELF DIAGNOSIS menu
10 COMMUNICATION TEST Displays COMMUNICATION TEST menu
11 AIS ALARM Displays ALARM INFORMATION screen
12 SENSOR STATUS Displays SENSOR STATUS menu
13 MY CONTLOLLER Displays MY CONTLOLLER menu
14 REGIONAL CHHANNEL Displays REGIONAL CH SETTING
15 PASSWORD Displays PASSWORD screen
16 SART TEST SET Displays SART TEST MODE SET menu
17 LONG-RANGE SET
Displays LONG RANGE SET menu
18 SILENT MODE
Displays SILENT MODE setting
19 NON USE No operation by USER key
USER KEY ASSIGN
USER KEY: 8
▲ MESSAGE
MAINTENANCE
SET UP
SELF DIAGNOSIS
▼ COMMUNICATION TEST