JRC JLR-21 - Page 95

5-31
1. Press the keys to move the cursor and select an item.
2. Press the key, and select the data I/O type. (Depending on the type, the screen change
flow may vary)
3. Select the NMEA VER, BIT RATE, and SENTENCE.
The following submenus are available.
• SENSOR THROUGH: Outputs through data from the sensor. Connects to equipment requiring
high speed output (radar, etc.). (Select from NMEA, NSK, AD-10 or IEC)
• DATA OUT1: Select from NMEA, NSK, AD-10 or IEC.
• DATA OUT3: Select NMEA, NSK or IEC.
• DATA OUT4/IN4: Select from NMEA, NSK, BEACON, IEC or 4341.
CCRP data can be entered for CCRP. (CCRP sentence)
Current data can be entered for CURRENT. (CUR and VBW sentences)
Both input and output settings can be set by this port (DATA OUT4/IN4).
Select from the following:
Even if the input setting is "OFF", the ACK, ACN and HBT sentence can
be received.
Selection Output
(DATA IN/OUT2
9,10 pins of connector)
Input
(DATA IN/OUT2
1,2 pins of connector)
Purpose
NMEA/OFF NME
A
Off For outputtin
g
NME
A
NSK/OFF NSK Off For outputtin
g
NSK
BEACON/OFF Dedicated setting for
beacon
(
4800bps
)
Off For connecting beacon
receiver
IEC/OFF IEC Off For outputting IEC
For connection BAM
4341/OFF Dedicated setting for
JLR-4341
(
4800bps
)
Off For connecting JLR-4341
NMEA/CURRENT NMEA
(4800bps)
Dedicated setting for
tidal current meter
(
4800bps
)
For inputting current meter and
outputting NMEA
simultaneousl
y
BEACON/CURRENT Dedicated setting for
beacon (4800bps)
Dedicated setting for
tidal current meter
(
4800bps
)
For connecting beacon
receiver and inputting current
meter simultaneousl
y
IEC/CURRENT NMEA
(4800bps)
Dedicated setting for
tidal current meter
(
4800bps
)
For inputting current meter and
outputting IEC simultaneously
4341/CURRENT Dedicated setting for
JLR-4341(4800bps)
Dedicated setting for
tidal current meter
(
4800bps
)
For connecting JLR-4341 and
inputting current meter
simultaneousl
y
.
NMEA/CCRP NMEA Dedicated setting for
CCRP
For inputting CCRP and
outputting NMEA
simultaneousl
y
BEACON/CCRP Dedicated setting for
beacon (4800bps)
Dedicated setting for
CCRP (4800bps)
For connecting beacon
receiver and inputting CCRP
simultaneousl
y
.
IEC/CCRP NMEA Dedicated setting for
CCRP
For inputting CCRP and
outputtin
g
IEC simultaneousl
y
4341/CCRP Dedicated setting for
JLR-4341(4800bps)
Dedicated setting for
CCRP (4800bps)
For connecting JLR-4341 and
inputting CCRP
simultaneousl
y
.
• DATA OUT5: Select NMEA, NSK or IEC.
• LOG PULSE: Select from OFF, 200p/NM, or 400p/NM.
Procedure