JUKI DDL-8000A Engineer's Manual

vii
PRECAUTIONS TO BE TAKEN SO AS TO USE THE DDL-8000A
SERIES MORE SAFELY
1. Neither open the pulley cover nor touch the parts inside the pulley cover with the power
remained on in order to prevent accidents due to electrical shock.
 2.To
avoidpersonalinjury,neverputyourngersundertheneedlewhenyouturnONthe
powerswitchoroperatethesewingmachine.
 3.Toavoidpersonalinjury,neverputyourngersintothethreadtake-upcoverwhilethesew-
ing
machineisinoperation.
4. To avoid personal injury, turn OFF the power switch when you tilt the machine head.
 5.Toavoidpersonalinjury,becarefulnottoallowyourngersinthemachinewhentiltingthe
machine head.
 6.Besuretomountthemachineheadsupportbaronthemachinetablesothatitsheight
from the table surface becomes 55 to 60 mm.
 1.Donotoperatethesewingmachinewiththepulleycoverandthengerguardremovedin
ordertoprotectagainstpersonalinjury.
 2.Neitherplacengers,hairand/orclothesnorputanythingintheareanearthethreadtake-
up
leverwhilethesewingmachineisinoperationinordertoprotectagainstpersonalinjury
duetoentanglement.
 3.Keepngersawayfromthethreadtake-upcoverandtheneedlewhenturningthepoweron
inordertoprotectngersandhandsagainstinjury.
4. To avoid personal injury, turn OFF the power switch when you tilt the machine head.
 5.Thehookrotatesatahighspeedwhilethemachineisinoperation.Topreventpossible
injurytohands,besuretokeepyourhandsawayfromthevicinityofthehookduringoper-
ation.
Inaddition,besuretoturnOFFthepowertothemachinewhenreplacingthebobbin.
6. So as to avoid personal injuries caused by abrupt start of the machine, turn OFF the power
switch
andascertainthatthesewingmachinedoesnotrunevenifthestartingpedalisde-
pressed
whenperformingsuchworksasinspectionoradjustmentofthesewingmachine,
cleaning,threading,replacingtheneedle,etc.
7. So as to avoid electrical shock hazards, do not operate the machine with the power supply
earth wire removed.
 8.So
astoavoidelectricalshockhazardsandaccidentscausedbydamagedelectricalcom-
ponents,
besuretoturnOFFthepowerswitchbeforeinserting/detachingthepowerplug.
9. So as to avoid personal injuries caused by abrupt start of the machine, turn OFF the power
switch
whenleavingthesewingmachinetable.
10. So as to avoid personal injuries caused by abrupt start of the machine, turn OFF the power
switch when the electricity fails.
11.To
preventres,periodicallydrawoutthepowerplugfromtheplugsocketandcleanthe
root of the pins and the space between pins.
12. The motor does not produce noise while the machine is at rest. To avoid possible accidents
due to abrupt start of the machine, be sure to turn OFF the power to the machine.
13.Be
carefulofhandlingthisproductsoasnottopourwateroroil,shockbydropping,and
the like since this product is a precision instrument.
14. In a domestic environment this product may cause radio interference, in which case the
user may be required to make corrective actions.

JUKI DDL-8000A Specifications

General

Stitch Type	Lockstitch
Motor Type	Direct-drive motor
Thread Trimmer	Automatic
Max. Stitch Length	5mm
Needle Bar Stroke	30.7mm
Lift of the Presser Foot	By hand: 5.5mm, By knee: 13mm
Control Panel	Digital
Lubrication	Automatic