JUKI IT-100 - Page 82

– 79 –
6
51
2
3
4
6
A
1
A
■
MACaddressconrmationscreen
1) The MAC address is displayed in A. When you press switch
6
, the network setting screen is displayed.
■
IPaddressconrmationscreen
1) When you press switch
1
or
2
, the IP address acquisition method is changed over as described below.
DHCP
→
AUTO
→
Direct input
2) In the case the IP address is directly input, the IP address can be set by pressing switch
3
or
4
.
3) When you press switch
5
, the network setting screen is displayed.
4) When you press switch
6
, the input you have made is conrmed. If you have changed the data, the
power OFF screen is displayed.
5) Turn the power off to nish the operation.
■
Serialnumberconrmationscreen
1) The serial number of the motor is displayed in A. When you press switch
1
, the network setting screen
is displayed.