– 35 –
5
Select the 1st bar-tacking shape.
Select the shape you desire to sew from among 5
kinds of the 1st bar-tacking shape buttons (F).
When it is selected, the total sewing shape
in which the 1st bar-tacking shape is used is
displayed.
6
Select the sewing shape.
Select SEWING SHAPE button (G) you desire to
sew.
7
Finish the selection of sewing shape.
Press ENTER button (H)tonishthe
selection of the shape. Then the sewing shape
which has been selected is displayed in the data
input screen (blue). The initial value of sewing
data is inputted according to the selected sewing
shape.
Note) Number of sewing shapes to be displayed
changes according to the level selected in the
sewing shape selection level of memory DIP
switch (level 2) .
→
Refer to
26. CHANGING MEMORY SWITCH
DATA, p.77
.
F
G
H
To Next Page
Loading...
