ā 81 ā
Item Setting range Edit unit Initial display
Presser size length (Type 5)
When type 5 of U14 Kind of presser is
set, input the length of the presser.
10.0 to 120.0 0.5mm 10.0mm
Sewing start position (Feed direction)
Sewing start position in terms of presser
is set. Set this item when starting position
is desired to be shifted due to overlapped
section or the like.
2.5 to 110.0 0.1mm 2.5mm
Cloth cutting knife size
Input knife size used.
3.0 to 32.0 0.1mm 32.0mm
Function of plural motions of cloth cutting knife
Ineffective/effective
--- --- Ineffective
: Ineffective
: Effective
Function of thread breakage detection Ineffective/
effective
--- --- Effective
: Ineffective
: Effective
Selection of presser position at the time of ON of
READY key (Up/Down)
Presser foot position when READY key is pressed is
set.
--- --- Presser UP
: Presser up
: Presser
down
Selection of presser position at the time of
completion of 1-cycle (Up/Down)
Presser foot position when 1-cycle is completed is set.
--- --- Presser UP
: Presser up
: Presser
down
Needle thread trimming release motion
start distance
Distance from start of sewing to start of
trimmer release motion of needle thread
trimmer motor is inputted.
0 to 15.0 0.1mm 1.0mm
To Next Page
Loading...
