JUKI LBH-1790 - Page 94

– 93 –
Error
code
Description of error
How to
recover
Place of
recovery
E486 Eyelet knife length error
When the shape is not formed since the eyelet knife
length is too short in case of eyelet shape.
Possible to
re-start after
reset.
Sewing data
input screen
E487 Eyelet shape length error
Eyelet shape length is too short to form the shape in
case of eyelet shape.
Possible to
re-start after
reset.
Sewing data
input screen
E488 Flow bar-tacking compensation error
When bar-tacking length is too short to form the shape
incaseofowbar-tackingshape.
Possible to
re-start after
reset.
Sewing data
input screen
E489 Knife size error (at the time of plural motions of knife)
When knife size is larger than cloth cutting knife size.
Possible to
re-start after
reset.
Sewing data
input screen
E492 Presser size over of basting
When stitching data of basting exceeds presser
size.
Possible to
re-start after
reset.
Sewing data
input screen
E493 Presser size over of tie stitching at sewing end
When stitching data of tie stitching at sewing end
exceeds presser size.
Possible to
re-start after
reset.
Sewing data
input screen
E494 Presser size over of tie stitching at sewing start
When stitching data of tie stitching at sewing start
exceeds presser size.
Possible to
re-start after
reset.
Sewing data
input screen
E495 Presser size error (Width direction : right only)
When stitching data exceeds the size of right only of
width direction of presser.
Possible to
re-start after
reset.
Sewing data
input screen