JUMO LOGOSCREEN - 5 Setup software

93
5 Setup software
The setup software is used for the easy creation of configuration files, and to
configure the devices from a PC.
5.1 Hardware and software requirements
The following hardware and software requirements have to be met for
installing and operating the setup software:
Minimum
configuration
- IBM-PC or compatible PC with Pentium III
1
processor or higher,
- 128Mbyte main memory,
-CD drive,
-mouse,
- one free serial interface or network connection, or CompactFlash memory
cards (depending on the type of data transmission to the recorder),
- 120Mbyte free space on hard disk and
-Microsoft Windows
2
NT4.0, 2000 or XP.
In addition, the following items are required for communication between the
PC and the recorder, such as:
- reader/writer for CompactFlash memory card or
- PC interface cable including adapter (only when using the setup interface)
or
- serial interface cable (when using the RS232C or RS422/485 interface) or
- network connection (when using the Ethernet connection).
Recommended
configuration
-Pentium IV
- Windows 2000 or XP
- 256Mbyte main memory
- 2GByte free space on hard disk for data
1. Pentium is a registered trademark of the Intel Corporation
2. Microsoft and Windows are registered trademarks
of the Microsoft Corporation