EasyManuals Logo

Jumper T16 User Manual

Jumper T16
84 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #10 background imageLoading...
Page #10 background image
8
Click Save to start backing up the firmware.
After the backup is complete, you can see the backup file under the path you just selected.
2.3. Backup models and settings
Open the Companion software and set the remote-control model to T16 in the setup menu.
Put the remote control into BOOTLOADER mode and connect the computer with a USB
cable.
Click the read/write menu and select to read the model and configuration from the remote
control (as shown below)

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Jumper T16 and is the answer not in the manual?

Jumper T16 Specifications

General IconGeneral
Channels16
Operating SystemOpenTX
USB PortYes
External Module SupportYes
SD Card SlotYes
SpeakerYes
Vibration AlertYes
BacklightYes
GimbalsHall sensor
Module BayYes
Transmitter Frequency2.4GHz
Antenna Gain2dBi
Battery Capacity3000mAh
Operating Current200mA
Charging PortYes
Internal ModuleJP4-in-1 Multi-protocol Module

Related product manuals