Need help?Do you have a question about the Jumper T16 and is the answer not in the manual?
General| Channels | 16 |
|---|---|
| Operating System | OpenTX |
| USB Port | Yes |
| External Module Support | Yes |
| SD Card Slot | Yes |
| Speaker | Yes |
| Vibration Alert | Yes |
| Backlight | Yes |
| Gimbals | Hall sensor |
| Module Bay | Yes |
| Transmitter Frequency | 2.4GHz |
| Antenna Gain | 2dBi |
| Battery Capacity | 3000mAh |
| Operating Current | 200mA |
| Charging Port | Yes |
| Internal Module | JP4-in-1 Multi-protocol Module |
Discusses precautions for use, export, and general safety.
Details regulations and compliance for exporting the product.
Advises on safe flying practices and potential interference.
States that the firmware is experimental and limits liability.
Outlines licensing and copyright information for the JumperTX project.
Details prerequisites and preparation steps before firmware installation.
Explains how to back up the remote control's firmware.
Guides on backing up model configurations and settings.
Describes the initial startup process and potential warnings.
Introduces the primary display screens and navigation elements.
To Next Page
