47
Switch: The switch position (physical or logical) can enable/disable this input line.
The Side: Side parameter limits the effect of the line to only one side of the source:
--- (enabled within the full source range)
x>0 (enabled only when source > 0)
x<0 (enabled only when source > 0)
Trim: Here you select the spinner source to add to the input source:
Off (no fine-tuning source enabled)
On (Enable the fine tuning source of this joystick)
Add rudder trimming to Rud input
Add elevator trimming in Ele input
Add throttle trimming in the Thr input
Add aileron trimming in the Ail input
You can use the rudder trim switch to control the aileron trim.
For fine-tuning to work, they must be enabled in the Inputs and Mixer pages.
3.9. Mixer
The Mix Control page allows you to combine as many input sources as you want and map them to
any of the 32 output channels. These next logical outputs are then adapted to the mechanical properties
of the model using the next page (Outputs).
You have complete flexibility to control the mix from any input to any output channel.
A mix control connects an input to the channel it is in. The input is configured in the Inputs page,
which defines the transition from the physical source to the logical input.
The mixing page also allows some remote 32 channels to be used as virtual functions for a clean
design (for example, mixing multiple inputs into one reusable function and then assigning it to one or more
channels) The settings of the Outputs page are not considered in these functions.
All inputs range from -100% to + 100%. The joystick, knob, slider, channel, CYC source, and coach
input will vary proportionally within this range.
If the servo of the #3 plug that you want to connect to the receiver is controlled by the lift (ELE), you
only need to create a mix on the CH3 and use the Ele input as the source.
Each channel can have many rows and you can choose between each row. Press and hold the ENT
key and select Insert Before/After to create a new line.
By default, all rows on the same channel are added together, but a row can also be multiplied before
it, or replaced.
To Next Page
Loading...
