40
Bind on powerup: The remote control is switched on when the power is turned on, and
some protocols are optional.
Low power mode: Some protocol optional features.
R9M: Frsky 900MHZ tuner module.
RF Power: Set the R9M module transmit power.
SBUS: Turn on the external tuner SBUS output.
Refresh rate: Can be selected between 6 and 40 milliseconds, the default is 7
milliseconds. Set to normal to normal or set to not inverted.
Warning:output level is VBAT: Displays the output battery voltage.
Trainer Mode: Set the master-slave mode of the coaching port.
Master/Jack: Master mode, coach.
Slave/Jack: From mode, the student (using the emulator with dongle also sets this
option) can set the frame length and pulse length in slave mode. (Set as the extended PPM
high frequency module)
3.6. Heli Setup
This page allows you to select the type of swashplate, set control limits via Swash Ring,
and assign CCPM channels (check "noheli" when downloading firmware to omit this page) This
section is used to set up CCPM (Cyclic/Collective Pitch Mixing) for helicopters.
To Next Page
Loading...
