10
Note: Before disconnecting the USB connection, remember to eject the device
and then disconnect it to prevent damage to the contents of the SD card file.
2.4. Upgrade remote firmware using Companion
software
Too be added, not currently supported
2.5. Companion Software Introduction
Too be added, not currently supported
2.6. First boot
Press and hold the power button to turn on the machine. Before entering the main interface, the
system will check the position of the throttle stick and switch and other starting conditions. If the
starting condition is not met, there will be a corresponding error prompt, which requires user
operation to clear or press any key to jump. Over.
Throttle warning: This is a warning that the throttle is not at the lowest position when starting.
You can put the throttle stick to the lowest position or press any key to skip, or you can close it
in the Throttle state option in the MODEL SETUP. Throttle alarm.
To Next Page
Loading...
