Name: Jumper T16
Brand: Jumper
Rating: 5 (1 reviews)

To Next Page

To Previous Page

The preparation section describes what you need to do before you start installing the firmware.

Then, depending on the tool you are using, the installation steps will overwrite the original

program. These steps apply to version upgrades or installations of different versions and

developer versions.

2.1. Ready

First, make sure your remote is fully charged before you start installing firmware. in

Download T16 firmware (JumperTX 2.2.3 English) at https://www.jumper.xyz/downloads,

where English is the menu language for the remote control. 2.2.3 refers to the version number

of the JumperTX firmware. Note: Do not use the DfuSe tool downloaded from

STMicroelectronics!

You can download the firmware upgrade tool here:

Https://www.jumper.xyz/downloads

If you are using WindowsTM, you will need to install the appropriate USB driver. See the

Windows Driver Installation section.

Unzip and install the downloaded tool.

If you are upgrading an older version of JumperTX firmware, it is highly recommended that

you back up your remote's configuration file to make sure you don't lose any model or remote-

control configuration.

Windows driver installation.

The T16 uses the STM32 Bootloader driver. Can be downloaded here:

Https://zadig.akeo.ie/

Questions and Answers:

Need help?

Do you have a question about the Jumper T16 and is the answer not in the manual?

Jumper T16 Specifications

General