Jumper T16 - Page 48

46
(SrcValue x weight)+Offset =Result
(100 x -50/100)+50=0
(0 x -50/100)+50=50
(-100 x -50/100)+50=100
Curve:
Diff: The differential (usually down the aileron stroke) is used to reduce unfavorable yaw
and improve cornering/maneuvering characteristics. (Default = 0, range -100 to +100). Although
available here, it is best to set it on the mixing page.
Expo: The default curve is Expo, the default value is 0. This means that the response is
linear (ie no curve). A positive value will make the response weaker around 0, while a negative
value will make the response sharper around 0.
Func: If the setting is changed to Func. (predefined function curve type):
--- (output is always equal to source)
X>0 If the source is >0, then enter the follower source.
If source <0, then enter=0.
X<0 If source <0, then enter the follower source.
If the source > 0, then enter = 0.
|X| Input follows the source, but is always positive (also known as "absolute value")
f>0 if source >0, then enter = 100%
If source <0, then enter = 0
f<0 if source <0, then input = -100%
If source >0, then enter = 0
|f| If source >0. Then enter = 100%
If source <0, then enter = -100%
Cstm: Select the predefined custom curves numbered CV1 to CV32 (or their reverse,
ie !CV1 to !CV32). After selecting the curve number, press and hold the ENT key to open the
curve page. After configuring the curve, press the RTN button to return.
Modes: Allows you to select the flight mode that this line can activate. By default, all flight
modes are active, but if the flight mode number has been blanked, the flight mode will not be
activated.