69
The Lipo voltage sensor FLVSS adds the following parameters to the list:
Cels: Total battery voltage. In order to get a single battery voltage, a new calculation sensor needs
to be defined.
Name: Cmin or Cmax.
Type: Calculated
Formula:Cell
Cell sensor: Select from active Lipo voltage sensors, for example, Cels.
Cell Index: lowest, 1, 2, 3, 4, 5, 6, highest.
Log: If checked, it will be logged to the SD card. Please note that the record must still be started by
the Special Function.
Distance:
The GPS sensor adds the following parameters to the list:
GPS: Longitude and latitude.
Galt: Height.
GSpd: Speed.
Date: date, time.
To get the distance from the GPS power-up position to the current position, define a new
calculation sensor.
Name:Dist
Type:Calculated
Formula:Distance
Unit:m
GPS sensor: Set this to "---" and we do not use height values for this calculation.
Alt sensor: Select the "Galt" entry from the list of activity parameters.
Logs: If checked, will be logged to the SD card. Please note that the record must still be started by
the Special Function.
Current sensor 40A
The 40A current sensor adds the following parameters to the list:
Curr:Current
To get the consumption (battery in mAh), define another new calculation sensor:
Name:
Type:Calculated
Formula:Consumpt
To Next Page
Loading...
