68
If Ratio is "-", the telemetry value is calculated as follows: (sensing value divided by 10)
(received value/10) + Offset=displayed value
Or, if Ratio is not "-", the telemetry value is calculated as follows:
[(received value / 255) * Ratio] + Offset = displayed value
The ratio allows the received sensor values to be corrected or converted, for
example between km / h or between sections.
Offset: between -3000 - +3000.
Auto Offset: When checked, it will be automatically reset to zero. For example, when
the Vario sensor is at ground level when the power is turned on, it stores the first value received
after reset as zero. This provides an "AGL" reading instead of a "above sea level" reading.
Positive: Limit any negative value to zero.
Filter: When selected, the moving average of 4 past values will be calculated.
Logs: If checked, the SD card will be logged. Please note that the log record must
still be started by the Special Function. This option only makes the data available for recording.
Calculate sensor settings:
Type:Calculated
Formula:
Add, Average, Multiply: Values can be added, averaged, or multiplied.
Min, Max: You can extract up to or up to a set of 4 values.
Totalize: This function adds each value as it is received.
Consumption: This value will be integrated over time.
Unit: "-", V, A, mA, kts, m/s, f/s, kmh, mph, m, ft, degC, degF, %, mAh, W, dB, rpm,
g, deg, ml, fOz
Precision: Shift the decimal to 0 or 0.0 or 0.00.
Source1-Source4: Select from any active sensor.
Auto Offset: Automatically resets to zero when checked.
Positive: Limit any negative value to zero.
Filter: When selected, the moving average of 4 past values will be calculated.
Persistent: When selected, this value is retained during a power outage and
resumes during power up. Very useful for functions such as mAh consumption.
Logs: If checked, the SD card will be logged. Please note that the log record must
still be started by the Special Function.
Professional features:
Lithium battery cell voltage:
To Next Page
Loading...
