70
Sensor: Curr
Unit: mAh
Persistent: When selected, this value will remain during power down and resume
during power up.
Logs: If checked, will be logged to the SD card. Please note that the record must
still be started by the Special Function.
Variometer settings:
The vario sensor adds the Vspd and Alt parameters to the sensor list.
Source: To enable vario, set "VSpd" as the source on the main telemetry page
under the "Variometer" heading.
Range: Sets the maximum expected sink rate (-17 to -3, default -10m/s) and the
maximum rate of climb (3 to 17 and defaults to 10m/s) for the sounds generated by
the Vario custom function.
Center: Sets the sink/climb rate limit for the center "dead zone" (-2.1 to 0.5,
default -0.5 and -0.5 to 2.0, default is 0.5m/s). Replace "Tone" with "Silent" to turn off
the tone in the center range.
If you want to use the switch to open and close vario as shown below.
To Next Page
Loading...
