38
Failsafe Mode: Out of control protection settings. (D16/LR12 protocol only)
Hold: Holds the last output value. (For example, 50% throttle is out of control,
the receiving opportunity keeps 50% throttle until the signal is restored)
Custom: Customize the runaway protection receiver output value. Select Set to enter the runaway
protection custom settings page, and you can set the runaway protection value separately for each
channel. Scroll to the channel you want to set, press ENT to enter the edit mode, set the value and press
the ENT key to save. You can also press and hold the ENT key to set the HOLD and NONE values.
No Pulses: Turn off the pulse. (For flight control with GPS can automatically return to the flight, it is
recommended to use the custom settings to trigger the flight control return mode, instead of the flight
control to automatically return to the air after detecting the loss of control)
Receiver: Use the receiver's runaway protection settings.
To Next Page
Loading...
