28
Set an enable switch, such as SA on the graph (the arrow represents the enabled switch
position)
Select Trainer and set the parameter to "---".
Finally check to enable this feature.
Add the following settings to the slave.
In the Model Setup page, set the Trainer Mode to Slave / Jack.
Turn off the internal and external tuner modules.
Before using the coaching function, it is recommended to test whether the coaching
function is available on the ground and the control direction is correct. Check that the Cal
value at the bottom of the screen is not close to 100%, and you can adjust it up and down
by the Multiplier value.
To Next Page
Loading...
