Jungheinrich KMS 100 User Manual

1298.GB
E 12
– Press push-button “Induction guide
on” (23).
– The drive wheel is automatically adju-
sted in straight direction and the indi-
cator light “Induction guide on” (24)
illuminates. The manual steering is
now inoperative.
– To prepare starting, grasp the handle
of the handrest with the left hand (two-
hand operation).
– Continue driving the truck with the
desired speed in the narrow aisle.
– Carry on driving the truck in the narrow
aisle with the desired speed.
Trucks with induction guide
– Drive the truck with reduced speed at
an angle towards the guiding wire.
For tracking-in the truck must not be
standing in parallel to the guiding wire.
The tracking-in angle must be smaller
than 35°.
The tracking procedure should be star-
ted in forward direction, since the least
time and distance are required in this di-
rection.
– When close to the guiding wires,
switch on the induction guidance with
the push-button (23).
Indicating light "induction guide active“
(24) is illuminated. The driving speed is
reduced.
When reaching the guiding wire, the au-
tomatic guidance of the truck is started.
The indicator “Tracking-in in progress”
(35) illuminates. The audible tracking si-
gnal sounds.
1298.GB
E 12
– Press push-button “Induction guide
on” (23).
– The drive wheel is automatically adju-
sted in straight direction and the indi-
cator light “Induction guide on” (24)
illuminates. The manual steering is
now inoperative.
– To prepare starting, grasp the handle
of the handrest with the left hand (two-
hand operation).
– Continue driving the truck with the
desired speed in the narrow aisle.
– Carry on driving the truck in the narrow
aisle with the desired speed.
Trucks with induction guide
– Drive the truck with reduced speed at
an angle towards the guiding wire.
For tracking-in the truck must not be
standing in parallel to the guiding wire.
The tracking-in angle must be smaller
than 35°.
The tracking procedure should be star-
ted in forward direction, since the least
time and distance are required in this di-
rection.
– When close to the guiding wires,
switch on the induction guidance with
the push-button (23).
Indicating light "induction guide active“
(24) is illuminated. The driving speed is
reduced.
When reaching the guiding wire, the au-
tomatic guidance of the truck is started.
The indicator “Tracking-in in progress”
(35) illuminates. The audible tracking si-
gnal sounds.

Jungheinrich KMS 100 Specifications

General

Brand	Jungheinrich
Model	KMS 100
Category	Forklifts
Language	English