05.10 EN
120
Operational fault displays
NOTE
When the overtemperature indicator (90)
is lit the performance of the truck
automatically reduces to 0% at a steady
rate from the point of the temperature limit,
as the temperature rises. The truck can
still be taken to the nearest workshop.
NOTE
When the engine oil pressure display (86) is lit the engine must be switched off
immediately.
XTow the truck if necessary, (see "Towing the truck" on page 124).
X Contact the manufacturer's customer service department.
XThe engine should only be started again once the fault has been removed.
Info messages
Item Display Function
68 DFG fuel supply display Graphic illustration of the fuel supply.
TFG with gas tank
69 WARNING – Lights up a single time to indicate
that the fuel supply is too low. Lights
up in conjunction with err xx xxx or
inf xx xxx to indicate a fault or
information.
– A warning signal sounds.
86 Engine oil pressure display – Engine oil pressure too low.
90 Overtemperature indicator – Hydraulic oil temperature too high.
– Coolant temperature too high.
– As the temperature rises, the truck's
performance is automatically and
steadily reduced to 0%.
91 Charge current indicator – Battery not charging.
– The truck can still be taken to the
nearest workshop.
Display Meaning
134 Hydraulics zero position on power up
– A hydraulic function or the horn applied during power up.
– The hydraulic function applied will not be performed.
156 – Recorded speed too high.
km/h
R
699086
91
68
To Next Page
Loading...
Need help?
General
