87
05.10 EN
4.12 Operating the lift mechanism and integrated attachments
WARNING!
Accident risk when operating the lifting device and integrated attachments
Other people can be injured in the truck's hazardous area.
The hazardous area is defined as the area in which people are at risk from the truck
movement, the load handler, attachments etc. This also includes areas which can be
reached by falling loads or lowering operating equipment.
Apart from the operator (in the normal operating position) there should be no other
people in the truck's hazardous area.
XInstruct other people to move out of the hazardous area of the truck. Stop working
with the truck if people do not leave the hazardous area.
XThe truck must be prevented from being used by unauthorised people if people do
not leave the hazardous area despite the warning.
XOnly carry loads that have been correctly secured and positioned. Use suitable
protection measure to prevent parts of the load from tipping or falling down.
XNever exceed the maximum loads specified in the capacity chart.
XNever stand underneath a raised load handler.
XDo not stand on the load handler.
XDo not lift other people on the load handler.
XDo not reach through the mast.
XThe controls should only be operated from the driver’s seat, and never suddenly.
XThe driver must be instructed in how to operate the lifting device and the
attachments.
4.12.1 Operating the lift mechanism with the SOLO PILOT
Lifting and lowering
Requirements
– To prepare the truck for operation, (see
"Preparing the truck for operation" on
page 72)
Procedure
• Pull the Solo-Pilot lever (144) in direction H to
raise the load.
• Push the Solo-Pilot lever (144)in direction S
to lower the load.
The load is now raised / lowered.
Z When the limit position for the operation has been reached (there will be a noise
from the pressure relief valve) release the lever. The lever will revert automatically
to neutral.
S
H
144
To Next Page
Loading...
Need help?
General
