Jungheinrich TFG 320s User Manual

05.10 EN
24
3.5 Tyre type
NOTE
When replacing tyres/rims fitted at the factory, always use original spare parts or tyres
approved by the manufacturer. Otherwise the manufacturer's specification cannot be
guaranteed.
If you have any queries please contact the manufacturer's customer service
department.
*) The models listed in the table correspond to the standard version. Other tyres can
be used depending on the truck's equipment.
3.6 Engine Data
Description DFG / TFG
316s 320s
Front tyres
SE *) 6.50 - 10 6.50 - 10
Pneumatic*
6.50 – 10
14PR
6.50 – 10
14PR
Tyre pressure bar max 10.0 max 10.0
Torque NM 170 170
Rear tyres
SE *) 18x7-8 18x7-8
Pneumatic* 18x7-8 16PR 18x7-8 16PR
Tyre pressure bar max 9.0 max 9.0
Torque NM 200 200
Engine - DFG 316s/320s
Description DFG 316s DFG 320s
Cylinder/cubic capacity 4 / 1896 4 / 1896 cm³
Idle speed 900 900 rpm
Rated speed (without load) 2500 2500 rpm
Engine output 29 29 kW
Fuel consumption
60 VDI duty cycles/h
2,3 2,6 l/h [kg/h]
Engine - TFG 316s/320s
Description TFG 316s TFG 320s
Cylinder/cubic capacity 4 /1980 4 / 1980 cm³
Idle speed 900 900 rpm
Rated speed (without load) 2500 2500 rpm
Engine output 31 31 kW
Fuel consumption
60 VDI duty cycles/h
2,2 2,4 l/h [kg/h]

Jungheinrich TFG 320s Specifications

General

Brand	Jungheinrich
Model	TFG 320s
Category	Forklifts
Language	English