145
05.10 EN
6.26
Check the attachment is properly secured to the truck and the
supporting elements.
t
6.27
Check bearing points, guides and stops for wear and damage,
grease and clean these components.
t
6.28 Check the hydraulic ports and tighten if necessary. t
6.29 Check the cylinder seals. t
6.30 Check the cylinder piston rods and bushings. t
Maintenance intervals
Standard = t WAB C
Agreed performance levels
7.1 Carry out a test run with rated load. t
7.2 Demonstration after servicing. t
7.3 Lubricate the truck according to the lubrication schedule. t
Maintenance intervals
Standard = t WAB C
Steering
8.1 Test the hydraulic steering and its components. t
8.2 Test the hydraulic steering for leaks. t
8.3 Check the steering axle and steering knuckle for wear and damage. t
8.4 Check the stub axle and adjust if necessary. t
8.5 Grease the steering axle. t
8.6 Check the steer axle wheel bearings, adjust if necessary. t
8.7 Check the mechanical parts of steering column. t
Maintenance intervals
Standard = t WAB C
Hydraulic Operation
To Next Page
Loading...
Need help?
General
