79
05.10 EN
Neutral locking
If the driver leaves the truck without taking it out of gear, the truck will automatically
be set to neutral. To resume travel (sitting on the truck) all controls must be
deactivated, the travel direction switch must be set to neutral “N” and then the
required direction selected. The brake pedal must also be pressed briefly before a
command from the accelerator pedal or the operating functions can be accepted.
Dual pedal (optional equipment)
Requirements
– Truck prepared for operation, (see
"Preparing the truck for operation" on
page 72)
Procedure
Z For trucks with a dual pedal the travel
direction is selected via the accelerator
pedals (72;70). When the driver leaves the
truck, the truck is automatically set to
“Neutral”.
• To activate the accelerator pedal and the
operating functions press the brake pedal briefly.
• Release the parking brake, to do this press the parking brake button (103).
• Raise the fork carriage approx. 200 mm.
• Tilt the mast back:
• Apply the accelerator pedal (72) to travel forward. The travel speed is governed by
the accelerator (72).
• Apply the accelerator pedal (70) to reverse. The travel speed is governed by the
accelerator (70).
The truck travels in the direction selected.
72
70
73
To Next Page
Loading...
Need help?
General
