3. If you are using the straight DC power cable (CBL-JNP-PWR-DSUB), connect the green grounding wire
in each power cable to ground.
4. Connect each power supply to the power source, by inserting the DC connector into the power supply.
See Figure 32 on page 87, Figure 33 on page 87, or Figure 34 on page 88.
Figure 32: Connecting a Straight DC Power Cable to a DC Power Supply in a PTX1000
(CBL-JNP-PWR-DSUB)
Figure 33: Connecting a Right-Angle DC Power Cable to a DC Power Supply in a PTX1000
(CBL-JNP-PWR-DSUB2)
87
To Next Page
Loading...
