4
Initial Setup
23
7. Press the
button to select Auto Tuning and then press the OK button.
First Time Installation
ExitEXITSelect
AdjustMove
OK
Auto Tuning
8. Channel tuning will commence. This operation may take up to few minutes.
The display will show the progress of the tuning and the number of channels
found.
9. If you select DTV + ATV and you want to skip the DTV tuning during
scanning, press the MENU button to interrupt the tuning half way. A pop-up
menu will be display. Press the
buttons to select Ye s to confirm.
10. After tuning is complete, the channels are arranged in a preset order. If you
wish to skip channels, modify the preset order or rename channels, select
Channel Edit under the Channel menu (refer to page 31 for details).
Target Region Setting (UK Only)
During tuning your TV may have received signals from more than one transmitter. If this has occurred the Target Region Setting
screen will be displayed. This will enable you to select the correct regional transmission for the local news service that you require.
Press the
buttons to select each option’s setting and then press the OK button to confirm.
Country Code This will be shown as GBR for the UK.
Primary Region This will show the regional country (e.g. England, Wales, Scotland, NI).
Secondary Region
This will allow you to set the region for your local news service on BBC and ITV (e.g. London,
Beds and Cambs etc).
Tertiary Region
You may receive signals from more than one transmitter within the Secondary Region, (e.g
Beds and Cambs may have Luton or Sandy Heath).
Eco Friendly / Auto Standby Function
The latest eco-friendly power saving technology will automatically switch the TV into standby mode if the TV is left on and idle
for 4 hours or it does not receive an input signal for serveral minutes. A reminder screen will pop up and count down before the
switches to standby mode. Once the TV is switched to standby mode, the red LED indicator will illuminate on the front panel of
the TV.
Press the
button on the rear panel of the TV or on the remote control to turn on your TV. The red LED indicator will turn off and
a pop up message will be prompt on the screen AFTER wake up from standby. To turn off the auto standby function, please refer
to page 37 Auto Standby under the Time Settings section.
Channel Tuning
ExitEXITSkip
5 UHF CH 22 DTV%
MENU
ATV Channel(s)0:
DTV Channel(s)0:
Radio Channel(s)0:
Data Channel(s)0:
Select Country
GBR
SelectOK
Select Primary region
England
SelectOK
Select Secondary region
Cambridgeshire & Bedfordshire
London
SelectOK
Select Tertiary region
Cambridge
SelectOK
• Always disconnect the TV from the mains socket when not in use for a long period of time.
• The
button on the rear panel of the TV or on the remote control is only used for switching the TV into standby, it does
not disconnect the TV from the mains power. To completely disconnect the mains power, please remove the mains plug
from the mains socket.
To Next Page
Loading...
Need help?
General
