Keycards
Kaba Ilco Lodging Access Control System 91
Press the right <
X
> arrow to access the available Staff Areas that can be
encoded on the keycard. The available Staff Areas will be listed, defaulting
to NO.
Use the up <
S
> or down <
T
> arrows to select each Staff Area and
press the left <
W
> or right <
X
> arrow to set the value to YES if it is to
be encoded on the staff keycard. When the areas are set accordingly, press
<
>. The following is displayed when ready to encode specific Staff Areas
to a Staff card:
If all 16 Staff Areas are available and set to YES for a Staff keycard the
following is shown:
When all required parameters are set, press < > to encode the keycard
with access to the selected Staff Common Area(s).
4.6.2.2 Guest Common Areas encoding for staff keycard
Applicable Keycards: Section, Floor, Group, Zone, Area, and Bellman’s Master
To Next Page
Loading...
