Locks – Using and Programming
Kaba Ilco Lodging Access Control System 149
8. Press < > when ready to program the lock.
9. Only for a lock, insert the Programming keycard in the lock, and ensure the
green indicator is lit. For a RAC, use the Initialization keycard instead of the
Programming keycard to initialize communication.
10. Connect the communication cable from the FDU to the lock and press any key
on the FDU to send the programming to the lock.
The addresses are now assigned. Every time lock addresses are programmed, the
FDU sets the lock’s internal clock to the correct time, so there is no need to reset
the lock time. Remove the communication cable from the lock.
5.3.6 Programming Restricted Area Locks
Purpose: To program the address of a lock for a Restricted
Area. The only keycards accepted by Restricted Area
locks are the correctly addressed Restricted Area
keycard, and the Emergency keycard. Only one
address needs to be programmed into the lock, which
is the Restricted Area number (from 1 to 200).
Level Available Addresses Example
Restricted Area 1-200 169
Emergency Master - All
Table 5.3.6: Addresses for a Restricted Area 169 lock.
To Next Page
Loading...
