Locks – Using and Programming
Kaba Ilco Lodging Access Control System 145
Enter a number from 1 to 255 (eg: 2 for Inner Door) to change the addresses
selected.
Note: The Inner Door address must match the list of addresses programmed at the
factory for the Inner Doors of Common Door Suites.
7. Enter the new address. Change other addresses if necessary, and press < > when
ready to program the lock.
8. Insert the Programming keycard in the lock, and ensure the green indicator is lit.
Connect the communication cable from the FDU to the lock and press any key on
the FDU to send the programming to the lock.
The addresses are now assigned. Every time lock addresses are programmed, the
FDU sets the lock’s internal clock to the correct time, so there is no need to reset
the lock time. Remove the communication cable from the lock. The FDU will
return to the menu for the Common or Inner Door Suite menu and shows the
previous values used for the lock.
To Next Page
Loading...
