SAM
®
RF Operations Manual 115
Section 5: Keys
© SAFLOK WL 12/20/2007
Creating an Inhibit Zone Key (continued)
7. At the Select User Type PC dialog box, click the open circle next to Staff
and click OK.
Note: Inhibit Zone keys can only be assigned to staff members.
8. At the Staff List PC dialog box, staff members you
previously entered into the system will be listed in this
box. Simply click on the name of the person to receive
this key and click Select.
9. Back at the Create Inhibit Zone Key PC dialog box, the name of the person you selected will appear
in the box under The Key Is Assigned To. When you are satisfied with the settings for this Inhibit
Zone key, insert the key into the encoder and click OK.
Note: You must keep the key in the electronic key encoder base while the key image
spins on the PC screen.
Note: If a key is not currently in the electronic key encoder, the PC
will display an error screen until you insert a key into the electronic
key encoder.
Note: You must keep the USB cable connected between the
electronic key encoder base and the PC while the key image spins
on the PC screen. The PC screen will display, “The write operation
was successful!” Click OK on the PC message to continue creating
inhibit zone keys.
10. Reprogramming Locks – Now that you have created an
Inhibit Zone key, it is necessary to go to each and every unit,
suite, and common access lock in the zone and insert the
Inhibit Zone key. This will reprogram the locks to no longer
provide access to the lost key ID.
Note: Depending upon the size of your zone, you may wish to create several Inhibit Zone keys and enlist
the support of other staff members to help you reprogram these locks.
To Next Page
Loading...