Kaba Saflok SAM RF - Creating Additional Latch;Unlatch Keys

To Next Page

To Previous Page

SAM

RF Operations Manual 109

Section 5: Keys

5.9 Creating Additional Latch/Unlatch Keys

Note: The maximum number of duplicate keys is 64. After you have made 64 duplicate keys, you must

start over by making a new key for that level.

1. Be sure that the PC is turned on, the electronic key encoder device is plugged in an electrical outlet

and the USB cable between them is properly attached (see Section 2.5 “Installing the Electronic Key

Encoder and Utility Device”).

Note: The utility device need not be in the electronic key encoder to create keys.

2. Click on the Keys menu at the top of

the window or the Keys icon.

3. Point to Create, then select

Latch/Unlatch Key.

4. At the Create Latch/Unlatch Key PC dialog box, it

is important to accept (i.e., do not change) the

default setting of Duplicate Key because this will

now be a duplicate latch/unlatch key.

5. At this point, refer to the previous section to continue duplicating latch/unlatch keys until you have

enough keys to give to the appropriate number of staff members. Be sure to assign them as duplicate

keys to create a new key ID for each staff member.