Kaba Saflok SAM RF - 6.6 Replacing Lock Batteries

To Next Page

To Previous Page

SAM

RF Operations Manual 158

Section 6: Locks

6.6 Replacing Lock Batteries

If the lock information report indicates any locks with low voltage (below 5.0), it is recommended you

replace the set of double AA batteries immediately.

To replace the batteries, follow these simple steps:

1. Remove the two torque-head screws on the inside cover plate.

2. Remove the inside cover plate from the lock.

3. Remove all the old batteries.

4. Replace the batteries with a new set of AA alkaline batteries.

Note

: Do not use a mix of old and new batteries.

5. The lock will reinitiate. It will beep once, flash one red light, and then one green light.

6. Replace the back cover.

Note: A backup power source is used to power the lock’s internal clock for up to two minutes after the

batteries are removed. If more than two minutes elapse between removing the old batteries and replacing

them with new ones, you may have to reset the lock’s date and time using the utility device as discussed

in the previous section.