Kaba Saflok SAM RF - Page 164

SAM
®
RF Operations Manual 157
Section 6: Locks
© SAFLOK WL 12/19/2007
Resetting the Date/Time in Lock(s) (continued)
6. Connect the USB cable on the utility device to the lock’s receptive port located underneath the bottom
of the lock. You will need to remove the rubber cover on the lock’s receptive port to insert the USB
cable. Be sure that the connectors of the USB cable and the lock’s receptive port match up.
7. You will hear two beeps indicating that the
date/time have been set. The utility device
screen will display the message
“OPERATION COMPLETED REMOVE
DEVICE NOW Set Date/Time.”
8. Remove the USB cable from the lock. Replace the rubber cover on the lock’s receptive port. You may
continue resetting the date/time in additional locks or return the utility device to the electronic key
encoder base for reconnection and charging.
OPERATION COMPLETED
REMOVE DEVICE NOW
Set Date/Time