Kaba Saflok SAM RF - 3.2 Entering Zone Information

To Next Page

To Previous Page

SAM

RF Operations Manual 39

Section 3: The Site Design Process

3.2 Entering Zone Information

The site design process begins by entering information about any zones your property may have. Zones

are separate buildings or groups of locks. The SAM RF System allows you to group up to 50 zones. A

Zone key is the key that you will give to employees to allow them to gain access only to those units (and

any common access areas) within the zone or zones for which they have authorization.

If your property is only a single building, you may set up each floor as a different zone, or you can choose

not to set up zones at all. In this case, go to the next subsection “Entering Suite Lock Information.”

1. Click on the Management menu at the top

of the window or the Management icon.

2. Point to Site Design, then select Zones…

3. To begin entering zone information for your property at the Zone

Configuration PC dialog box, click on 1: ZONE 01 and then click

Edit.