Kaba Saflok SAM RF - Creating Inhibit Zone Keys

To Next Page

To Previous Page

SAM

RF Operations Manual 114

Section 5: Keys

5.12 Creating an Inhibit Zone Key

Note: The maximum number of duplicate keys is 64. After you have made 64 duplicate keys, you must

start over by making a new key for that level.

1. Be sure that the PC is turned on, the electronic key encoder device is plugged in an electrical outlet

and the USB cable between them is properly attached (see Section 2.5 “Installing the Electronic Key

Encoder and Utility Device”).

Note: The utility device need not be in the electronic key encoder to create keys.

2. Click on the Keys menu at the top

of the window or the Keys icon.

3. Point to Create, then select Inhibit

Zone Key.

4. At the Create Inhibit Zone Key PC dialog box, go to the Zone

pull-down box and confirm that you are creating an inhibit key

for the appropriate zone. If you set up zones correctly in the

site design process, all zones within your property will appear

in the pull-down box. Select the appropriate zone.

5. In the Select IDs to Inhibit box is a listing of all zone key IDs

created, along with the name of the staff member to whom you

wish to assign each key. Simply click in the box to the left of

the staff member(s) whose key(s) you wish to inhibit.

6. Name the person to whom you wish to assign the key in the

box under The Key Is Assigned To. Click the button to the

right of the box. (This button has a hand pointing to the right.)