SAM
®
RF Operations Manual 117
Section 5: Keys
© SAFLOK WL 12/20/2007
Creating Guard Check Keys (continued)
6. At the Staff List PC dialog box, simply
click on the name of the person to
receive this key and click Select. Any
staff members you previously entered
into the system will be listed in this box.
7. Back at the Create Guard Check Key PC dialog box,
the name of the person you selected will appear in the
box under The Key Is Assigned To. When you are
satisfied with the settings for this key, insert a key into
the encoder, and then click OK.
Note: You must keep the key in the electronic key encoder base while the key image
spins on the PC screen.
Note: If a key is not currently in the electronic key encoder, the PC will display an error
screen until you insert a key into the electronic key encoder.
Note: You must keep the USB cable connected between the electronic key encoder base and the PC
while the key image spins on the PC screen. The PC screen will display, “The write operation was
successful!”
Note: The “Keys Made This Session” number at the bottom of the PC dialog box will change to reflect
each key you create this session.
8. Click OK on the PC dialog box screen
message to create additional keys for staff
members. Follow the procedure described
above.
Note: It is recommended that you label each key as it is created to avoid confusion later.
To Next Page
Loading...