Kaba Saflok SAM RF

To Next Page

To Previous Page

SAM

RF Operations Manual 121

Section 5: Keys

Creating Diagnostics Keys (continued)

6. At the Staff List PC dialog box, any staff

members you previously entered into the

system will be listed in this box. Simply

click on the name of the person to receive

this key and click Select.

7. Back at the Create Diagnostics Key PC dialog box, the

name of the person you selected will appear in the box

under The Key Is Assigned To. When you are satisfied

with the settings for this key, insert a key in the encoder

and click OK.

Note: You must keep the key in the electronic key encoder base while the key image

spins on the PC screen.

Note: If a key is not currently in the electronic key encoder, the PC will display an error screen until you

insert a key into the electronic key encoder.

Note: You must keep the USB cable connected between the electronic key encoder base and the PC

while the key image spins on the PC screen. The PC screen will display, “The write operation was

successful!”

Note: The “Keys Made This Session” number at the bottom of the PC dialog box will change to reflect

each key you create this session.

8. Click OK on the PC dialog box screen message to

create additional keys for staff members. Follow the

procedure described above.

Note: It is recommended that you label each key as it is

created to avoid confusion later.

Kaba Saflok SAM RF - Page 127