Kaba Saflok SAM RF

To Next Page

To Previous Page

SAM

RF Operations Manual 124

Section 5: Keys

Creating Battery Check Keys (continued)

6. At the Staff List PC dialog box, any staff

members you previously entered into the

system will be listed in this box. Simply

click on the name of the person to receive

this key and click Select.

7. Back at the Create Battery Check

Key PC dialog box, the name of the

person you selected will appear in

the box under the words, “The Key

Is Assigned To.” When you are

satisfied with the settings for this

key, insert a key in the encoder and

click OK.

Note: You must keep the key in the electronic key encoder base while the key image

spins on the PC screen.

Note: If a key is not currently in the electronic key encoder, the PC will display an error screen until you

insert a key into the electronic key encoder.

Note: You must keep the USB cable connected between the electronic key encoder base and the PC

while the key image spins on the PC screen. The PC dialog screen will display, “The write operation was

successful!”

Note: The “Keys Made This Session” number at the bottom of the PC dialog box will change to reflect

each key you create this session.

8. Click OK on the PC dialog box screen message to create

additional keys for staff members. Follow the procedure

described above.

Note: It is recommended that you label each key as it is created

to avoid confusion later.

Kaba Saflok SAM RF - Page 130