SAM
®
RF Operations Manual 153
Section 6: Locks
© SAFLOK WL 12/19/2007
Get Lock Info (continued)
6. The utility device screen will display the
message “OPERATION COMPLETED
REMOVE DEVICE NOW Get Lock Info.” You
will hear two beeps. The lock information has
been retrieved. Remove the USB cable from the
lock. Replace the rubber cover on the lock’s
receptive port.
7. You may continue by inserting the USB cable attached to the utility device into additional locks for
which you wish to retrieve lock information.
Note: You can get lock info for up to 100 locks. You will need to return the utility device to the PC and
reprogram it in order to continue getting lock info for more than 100 locks.
8. When you have finished, bring the utility device with the attached USB cable to the electronic key
encoder base and your PC. Reconnect the USB cable to the back left hand side of the electronic key
encoder base and place the utility device in the base for recharging.
9. Be sure that all USB cables between the PC, electronic key encoder and utility device are attached.
The PC must be turned on and the electronic key encoder plugged in to an electrical outlet (see
Section 2.5 “Installing the Key Encoder and Utility Device”).
10. To read the lock information, point to the
Utility Device pull-down menu and select
Read Lock Info.
11. The PC screen will display the message “There are audit records
for [the number of locks previously read, up to 100] locks. Do you
wish to save the records of each lock for later report viewing?”
12. Click
Yes. The Output Options PC Dialog Box will appear.
OPERATION COMPLETED
REMOVE DEVICE NOW
Get Lock Info.
To Next Page
Loading...