SAM
®
RF Operations Manual 155
Section 6: Locks
© SAFLOK WL 12/19/2007
Get Lock Info (continued)
The Lock Information Report lists the locks that were checked in the order in which the utility device
retrieved the information. In addition, the report lists the following information:
•
Lock Type: Whether unit lock, suite lock or common access lock
•
Lock Name: Such as Pool or Unit 101
•
Date/Time: The date and time setting in the lock at the time the lock information was requested
Note:
Be sure to take a close look at the date and time settings of each lock. If there is a wide variance in
the times from one lock to the next, it is highly recommended that you reset the date and time in the
lock(s) using the utility device (see “Resetting the Date/Time in Lock(s)” later in this section).
•
Day: The day of the week the lock information was requested
•
Software Version: The version of the SAM RF System software that the lock was programmed with
•
Open/Close Cycle: The number of times the lock has been unlocked using an access key
•
Battery Voltage: The actual voltage of the batteries inside the lock. N
Note:
If a lock’s battery voltage is below 5.0, “LOW” will appear next to the voltage number to flag the lock
for possible battery change (see Section 6.6 “Replacing Lock Batteries”.)
If there are several pages to the report, the lock information report provides tools for going from one page
to another using either the buttons at the top of the box or the
Page menu. There are also options for
zooming in or zooming out of the report using either the
Zoom box or the Zoom menu.
15. To exit the lock information report, point to the
File menu and click Exit. This will return you to the
SAM RF System main menu screen.
To Next Page
Loading...