SAM
®
RF Operations Manual 37
Section 2: Installing the SAM RF System
© SAFLOK WL 12/19/2007
Using the SAM RF Software (continued)
Once you are logged on to the SAM RF System, all pull-down menus will be active, allowing you full
access to all the program’s features. The name of the person who is currently logged on to the SAM RF
System will appear at the top of the PC dialog box.
SAM RF will automatically log off the current user if
the system remains idle for more than five minutes.
The user will then have to log back on to the system
using his or her user ID and password.
Once you have full access to all the program’s features, you can complete the site design process,
configuring the SAM RF System specifically for your property. Although this takes some time, once it is
configured, the information contained in the system will require only minor changes in the future.
Configuring the SAM RF System entails the following:
• Adding new SAM RF System users, or employees who will have access to and use of the SAM RF
System. SAM RF allows you to assign varying levels of access to the system’s many features.
• Setting up zones that represent individual buildings or other areas within your property.
• Inputting unit numbers, either individually or by group.
• Setting up any common access locks, for areas such as for the pool gate or laundry doors.
• Setting up any suite doors that provide access to up to ten unit doors.
To Next Page
Loading...