SAM
®
RF Operations Manual 62
Section 4: Management Functions
© SAFLOK WL 12/19/2007
Creating Authorization Groups (continued)
4. Create and type a name for it in the Name field at the
top of the PC dialog box. It is recommended that the
name be something that is easily identifiable, such as
Maintenance or Work Order Access. We’ve added a
Unit Access authorization group as an example.
5. Below the Name field are two tabs – System
Authorizations and Key Authorizations – each with
a list of options from which to choose. A list of System
Authorization options with short definitions follows.
To select options, simply click in the small box next to
the option so a check mark appears in it.
System Authorizations
Read Key – Allows the user to use the electronic key encoder to read a key
Rename Unit – Allows the user to go into the site design section and change the names of units
Change Active State of Unit – Allows the user to go into the site design section and edit the active state
of a unit
Add Unit – Allows the user to go into the site design section and add additional units to the system.
Move Unit From Zone – Allows the user to go into the site design section and change a unit’s zone
assignment
Move Unit From Suite – Allows the user to go into the site design section and change a unit’s suite
assignment
Change Switch Mode of Unit – Allows the user to go into the site design section and change a unit’s
switch mode. Not applicable at this time
Rename Common Access Lock – Allows the user to go into the site design section and change the
names of common access locks
Change Active State of Common Access – Allows the user to go into the site design section and edit
the active state of a common access lock
Change Start/Stop Time of Common Access – Allows the user to edit the start and stop times of a
common access lock
Change Auto Open of Common Access – Allows the user to change the time a common access lock
will automatically open
To Next Page
Loading...